Shelly 2.5 che fine ha fatto
Buona sera. Lo shelly 2.5 non è più prodotto.. Potrei sapere con quale sostituirlo? .. Il nuovo shelly 2pm purtroppo ha si 2 canali ma non si può impostare il tipo di pulsante in modalità ciclica e quindi installarlo per sostituire un relè passo passo..
Buona sera. Lo shelly 2.5 non è più prodotto.. Potrei sapere con quale sostituirlo? .. Il nuovo shelly 2pm purtroppo a si 2 canali ma non si può impostare il tipo di pulsante in modalità ciclica e quindi installarlo per sostituire un relè passo passo..
-
salvatore58
- Messaggi: 1
- Iscritto il: mercoledì 28 novembre 2018, 18:10
ciao, puoi usare lo Shelly 2PM. Ho avuto lo stesso tuo problema ma dall'assistenza mi hanno dato questa soluzione:
Thank you for reaching out to us!
We apologize for the delayed response as we are currently experiencing a high volume of work.
We are delighted to inform you that this feature has been added to the Shelly Plus 2PM device as intended, starting from firmware version 1.0.7.
To access this feature, please follow these simple steps:
1. Access the device locally and enter its WebUI from its IP.
2. Click on one of the device's outputs (please ensure you are in Relay mode, not shutter mode).
3. Go to settings.
4. Refer to I/O settings.
5. Select the input mode as a button.
6. Click on the cycle switch.
Please note that this feature will only work with firmware version 1.0.7 or higher.
prova così ciao
Thank you for reaching out to us!
We apologize for the delayed response as we are currently experiencing a high volume of work.
We are delighted to inform you that this feature has been added to the Shelly Plus 2PM device as intended, starting from firmware version 1.0.7.
To access this feature, please follow these simple steps:
1. Access the device locally and enter its WebUI from its IP.
2. Click on one of the device's outputs (please ensure you are in Relay mode, not shutter mode).
3. Go to settings.
4. Refer to I/O settings.
5. Select the input mode as a button.
6. Click on the cycle switch.
Please note that this feature will only work with firmware version 1.0.7 or higher.
prova così ciao